Routing and WAN connections
430
11.9
N:N mapping
BAT54-Rail/F..
Release
7.54
06/08
In order to enable the gateway of the provider to monitor the networks of cli-
ents C and D, the administrator sets up an address translation to 192.168.1.x
also for the own network.
11.9.2 Configuration
U Setting up address translation
Configuration of N:N mapping succeeds with only few information. Since a
LAN can be coupled with several other networks via N:N, different destina-
tions can have also different address translations for a source IP range. The
NAT table can contain 64 entries at maximum, including the following infor-
mation:
D Index: Unambiguous index of the entry.
D Source address: IP address of the workstation or network that should get
an alternative IP address.
D Source mask: Netmask of source range.
D Remote station: Name of the remote station over that the remote net-
work is reachable.
D New network address: IP address or address range that should be used
for the translation.
For the new network address, the same netmask will be used as the source
address already uses. For assignment of source and mapping addresses the
following hints apply:
D Source and mapping can be assigned arbitrarily for the translation of sin-
gle addresses. Thus, for example, it is possible to assign the mapping ad-
dress 192.168.1.88 to a LAN server with the IP address 10.1.1.99.
D For translation of entire address ranges, the station-related part of the IP
address will be taken directly, only appended to the network-related part
of the mapping address. Therefore, in an assignment of 10.0.0.0/
255.255.255.0 to 192.168.1.0, a server of the LAN with IP address
10.1.1.99 will get assigned the mapping address 192.168.1.99.
Note: The address range for translation must be at minimum as large as the
source address range.
Note: Please notice that the N:N mapping functions are only effective when
the firewall has been activated. (’Firewall/QoS enabled’ → page 265)!
To Next Page
Loading...
Need help?
General
