Hirschmann BAT54-F Series - Assigning Network Zones to the DMZ

Routing and WAN connections
380
11.5 Demilitarized Zone (DMZ)
BAT54-Rail/F..
Release 7.54 06/08
Configuration with WEBconfig, Telnet or SSH
Under WEBconfig, Telnet or SSH client you will find the settings for the Eth-
ernet ports under the following paths:
11.5.2 Assigning network zones to the DMZ
Various network zones (address ranges) are assigned to the DMZ and the
LAN using the address settings. Depending on availability, WLAN interfaces
can also be selected.
Configuration with LANconfig
Addresses can be defined in LANconfig in the configuration area 'TCP/IP' on
the 'General' tab.
Configuration with WEBconfig, Telnet or SSH
Under WEBconfig, Telnet or SSH client you will find the settings for the Eth-
ernet ports under the following paths:
Configuration tool Menu/Table
WEBconfig Expert Configuration
 Setup  Interfaces  LAN
Terminal/Telnet
Setup/Interfaces/LAN
Configuration tool Menu/Table
WEBconfig Expert configuration
 Setup  TCP-IP
Terminal/Telnet
Setup/TCP-IP