LANtools network management
194
5.3
Scripting
BAT54-Rail/F..
Release
7.54
06/08
When configuring a device with scripts, any add-, set- or del- command
can lead to an (unintentional) update of the configuration in flash; to pre-
vent this, the update to flash function can be deactivated. After conclud-
ing the configuration, this function can be activated again with
flash Yes
.
Changes in the RAM configuration are then written to flash. The status
flash Yes/No
is stored globally.
Note: Supervisor rights are necessary to execute this command.
D
sleep
The sleep command allows the processing of configuration commands to
be delayed for a certain time period or to be scheduled for a certain time.
Syntax:
sleep [-u] value[suffix]
Permissible suffixes are
s
,
m
, or
h
for seconds, minutes, or hours; if no
suffix is defined, the units are milliseconds.
With the option switch
-u
, the sleep command accepts times in the for-
mat
MM/DD/YYYY hh:mm:ss
(English) or in the format
TT.MM.JJJJ hh:mm:ss
(German).
Note: Times will only be accepted if the system time has been set.
The sleep function is useful for a time-delayed reboot when testing an
altered configuration or for a scheduled firmware update for large-scale
roll-outs with multiple devices.
5.3.7 WLAN configuration with the wizards in
LANconfig
Highly convenient installation wizards are available to help you with the con-
figuration of BAT Access Points for your wireless LAN.
The settings include the general shared parameters and also the individual
settings for one or more logical wireless LAN networks (WLAN radio cells or
SSIDs).
To Next Page
Loading...
Need help?
General
