Installation DRAGON MACH4000
Release
01
07/2018
35
1.8 Management interfaces
1.8.1 V.24 interface (external management)
Figure 16: V.24 interface: location on the device (rear side of the device)
A serial interface is provided on the RJ45 socket (V.24 interface) for the local
connection of an external management station (VT100 terminal or PC with
corresponding terminal emulation). This enables you to set up a connection
to the Command Line Interface CLI and to the system monitor.
The socket housing is electrically connected to the front panel of the device.
The V.24 interface is electrically insulated from the supply voltage.
VT100 terminal settings
Speed 9600 Baud
Data 8 bit
Stopbit 1 bit
Handshake off
Parity none
Figure Pin
assignment
Function
1—
2—
3TxD
4GND
5—
6RxD
7—
8—
Table 4: Pin assignment of the V.24 interface
V.24
USB
1
2
3
4
5
6
7
8
To Next Page
Loading...
