Installation DRAGON MACH4000
Release
01
07/2018
37
1.8.3 SD card interface
Prerequisite:
Only use Hirschmann SD cards.
See “Accessories” on page 71.
Figure 18: SD card interface: location on the device (rear side of the device)
The SD card interface allows you to connect the AutoConfiguration Adapter
ACA31 storage medium. This is used for saving/loading the configuration
data and diagnostic information, and for loading the software.
On the front and rear side of the device there are LEDs that inform you about
the status of the interface.
To Next Page
Loading...
