Hirschmann DRAGON MACH4000 series - Installing the SD Card (Optional)

Installation DRAGON MACH4000
Release 01 07/2018
39
2.2 Installing the SD card (optional)
Prerequisite:
Only use the AutoConfiguration Adapter ACA31 storage medium.
See “Accessories” on page 71.
Figure 19: Inserting an SD card: location on the device (rear side of the device)
Proceed as follows:
 Deactivate the write protection on the SD card by pushing the write-
protect lock towards the middle of the card.
 Unscrew the top right side screw of the SD card slot cover.
 Slide the cover clockwise using the unscrewed screw. The SD card slot is
now accessible.