Installation DRAGON MACH4000
Release
01
07/2018
43
Figure 23: Mounting a media module: Installation (front side of the device)
2.5 Mounting the fan module
Hirschmann supplies fan modules in a ready-to-operate state. You have the
option to replace fan modules while the device is operating.
CAUTION
RISK OF INJURY FROM SPINNING FANS
After removing the fan module during active operation, the individual fans
continue to spin for a few seconds. Do not touch rotating fan blades. Do not
insert objects into rotating fan blades.
Failure to follow these instructions can result in injury or equipment
damage.
NOTICE
OVERHEATING OF THE DEVICE
The device may overheat if the fan module fails or is removed. Switch off
the device or replace the fan module within 2 minutes, otherwise failures or
damage to the device may occur.
Failure to follow these instructions can result in equipment damage.
To Next Page
Loading...
