Hirschmann DRAGON MACH4000 series - 6 Disassembly; Removing a Power Supply Unit

Installation DRAGON MACH4000
Release 01 07/2018
55
6Disassembly
6.1 Removing a power supply unit
Figure 29: Removing a PSU module: Disassembly (rear side of the device)
Proceed as follows:
 Remove the screws on the front panel of the power supply unit.
 Pull the power supply unit out of the slot.
 Seal the power supply unit slot on the basic device with a cover panel.
 Fasten the cover panel using the 2 screws on the basic device.
You find the prescribed tightening torque in chapter:
“General technical data” on page 60