Installation DRAGON MACH4000
Release
01
07/2018
41
2.3.2 Mounting the power supply unit
Hirschmann supplies the power supply modules in a ready-to-operate state.
You have the option of mounting the power supply units while the device is
operating.
Figure 21: Mounting a PSU module: Installation (rear side of the device)
Proceed as follows:
Remove the cover panel (if mounted) from the power supply unit slot on
the device.
Insert the power supply unit straight into the slot.
Fasten the power supply unit to the device by tightening the 2 screws.
You find the prescribed tightening torque in chapter:
“General technical data” on page 60
To Next Page
Loading...
