Installation DRAGON MACH4000
Release
01
07/2018
45
2.6 Installing and grounding the device
Mounting in a switch cabinet
Prerequisites:
Install the device in the 19" switch cabinet using sliding or mounting
rails.
This provides a more stable position of your device in environments
subject to vibration.
For more information on sliding/mounting rails and how to install them,
please contact your switch cabinet manufacturer.
The devices are designed to be mounted in a 19" switch cabinet.
In the delivery state, there are 2 pre-mounted mounting brackets on
the sides of the device.
Ensure adequate ventilation. If necessary, install an additional fan in
the switch cabinet to prevent the device from overheating.
Measure the depth of the 19" cabinet so that all the lines to be
connected can be fed in easily.
Proceed as follows:
Assemble the sliding or mounting rails in the 19" switch cabinet as
specified by the manufacturer.
Position the device on the rails in the switch cabinet.
Fasten the device in the switch cabinet by screwing it in with the
mounting brackets.
WARNING
ELECTRIC SHOCK
Install this device solely in a switch cabinet or in an operating site with
restricted access, to which maintenance staff have exclusive access.
Failure to follow this instruction can result in death, serious injury, or
equipment damage.
CAUTION
OVERHEATING OF THE DEVICE
Verify that all ventilation slits are clear when installing the device. Avoid
touching the device while it is operating.
Failure to follow these instructions can result in minor injury or
equipment damage.
To Next Page
Loading...
