Hirschmann DRAGON MACH4000 series - Mounting the Cover Panel and the Power Supply Unit (Optional); Mounting the Cover Panel

40
Installation DRAGON MACH4000
Release 01 07/2018
Figure 20: Inserting an SD card: opening the SD card slot cover (rear side of the
device)
 Push the SD card into the slot with the beveled corner on the right side.
 Slide the cover counterclockwise back into its original location using the
unscrewed screw. Secure the SD card by screwing the cover.
2.3 Mounting the cover panel and the power
supply unit (optional)
2.3.1 Mounting the cover panel
Prerequisite:
To comply with the EMC requirements, seal unused open slots with a cover
panel; you obtain cover panels as an accessory.
See “Order numbers” on page 71.
Proceed as follows:
 Place the cover panel over the power supply unit or media module slot of
the device.
 Fasten the cover panel to the device by tightening the 2 screws.
You find the prescribed tightening torque in chapter:
“General technical data” on page 60