48
Installation DRAGON MACH4000
Release
01
07/2018
2.8 Connecting the supply voltage
You have the option of supplying the supply voltage redundantly, without
load distribution.
The supply voltage is electrically isolated from the casing.
Note: The supply voltage is connected to the device casing through
protective elements exclusively.
Note: Seal unused PSU module slots with a cover panel. You obtain
additional cover panels as accessories.
See “Accessories” on page 71.
WARNING
ELECTRIC SHOCK
Start connecting the electrical wires only if all safety requirements listed in
chapter “General safety instructions” are fulfilled.
Failure to follow these instructions can result in death, serious injury,
or equipment damage.
WARNING
ELECTRIC SHOCK
Never insert pointed objects (narrow screwdrivers, wires, etc.)
– into the device or
– into the connection terminals for electric conductors or
– into the connection terminals for the signal conductors
Do not touch the connection terminals.
Failure to follow these instructions can result in death, serious injury,
or equipment damage.
WARNING
ELECTRIC SHOCK
Connect only a supply voltage that corresponds to the type plate of your
device.
Failure to follow these instructions can result in death, serious injury,
or equipment damage.
To Next Page
Loading...
