Installation DRAGON MACH4000
Release
01
07/2018
49
Figure 27: Connecting the power supply: PSU modules (rear side of device)
For every supply voltage to be connected, perform the following steps:
On the rear side of the device, plug a non-heating device cable with C13
coupling according to IEC 60320-1 into the power supply connection
(built-in C14 plug) of the PSU module.
Secure the coupling against falling out by sliding the safety catch of the
built-in non-heating appliance plug over the coupling.
Type of the voltages
that can be connected
Specification of the supply
voltage
Pin assignment
AC voltage Rated voltage range
110 V AC ... 240 V AC,
50 Hz ... 60 Hz
L
N
Outer conductor
Neutral conductor
Protective conductor
Table 6: Type and specification of the supply voltage, connections
To Next Page
Loading...
