Hirschmann DRAGON MACH4000 series - Removing the Device

Installation DRAGON MACH4000
Release 01 07/2018
59
6.5 Removing the device
Proceed as follows:
 Disconnect the data cables.
 Disable the supply voltage.
 Unplug every non-heating device coupling to disconnect the device from
the power supply.
 Disconnect the terminal blocks.
 Disconnect the grounding.
 To detach the device from its installation location, remove the screws from
the mounting brackets on the device.
WARNING
ELECTRIC SHOCK
Disconnect the grounding only after disconnecting all other cables.
Failure to follow these instructions can result in death, serious injury,
or equipment damage.