Hirschmann DRAGON MACH4000 series - Installing an SFP Transceiver (Optional); Operating the Device

50
Installation DRAGON MACH4000
Release 01 07/2018
2.9 Installing an SFP transceiver (optional)
Prerequisites:
Exclusively use Hirschmann SFP transceivers.
See “Accessories” on page 71.
Figure 28: Installing SFP transceivers: Installation sequence
Proceed as follows:
 Take the SFP transceiver out of the transport packaging (1).
 Remove the protection cap from the SFP transceiver (2).
 Push the SFP transceiver with the lock closed into the slot until it latches
in (3).
2.10 Operating the device
Proceed as follows:
 Enable the supply voltage.
123