Hirschmann DRAGON MACH4000 series - Removing a Media Module

Installation DRAGON MACH4000
Release 01 07/2018
57
6.3 Removing a media module
Figure 31: Removing a media module: Removal sequence (front side of the device)
Proceed as follows:
 Loosen the screws in the front panel of the media module.
 Open the locking mechanism of the media module by pressing the locking
levers outwards (1).
 Pull the media module out of the slot (2).
 Close the media module slot on the basic device using a cover panel.
 Fasten the cover panel using the 2 screws on the basic device.
You find the prescribed tightening torque in chapter:
“General technical data” on page 60
21