36
Installation DRAGON MACH4000
Release
01
07/2018
1.8.2 USB port
Figure 17: USB port: location on the device (rear side of the device)
The USB port allows you to connect the AutoConfiguration Adapter ACA22
storage medium. This is used for saving/loading the configuration data and
diagnostic information, and for loading the software.
See “Accessories” on page 71.
On the front and rear side of the device there are LEDs that inform you about
the status of the interface.
The USB port has the following properties:
Supplies current of max. 500 mA
Voltage not potential-separated
Connectors: type A
Supports the USB master mode
Supports USB 2.0
Figure Pin Function
1 VCC (VBus)
2 − Data
3 + Data
4 Ground (GND)
Table 5: Pin assignment of the USB port
To Next Page
Loading...
