Hirschmann DRAGON MACH4000 series - Page 47

Installation DRAGON MACH4000
Release 01 07/2018
47
Figure 26: Signal contact: 3-pin terminal block with screw lock; position on the device
(rear side of the device)
 Connect the signal contact lines with the terminal block connections.
 Fasten the wires connected by tightening the terminal screws.
 Mount the terminal block on the device using screws.
You find the prescribed tightening torque in chapter:
“General technical data” on page 60
Signal contact
1 NC Normally closed contact
2 CO Changeover contact
3 NO Normally open contact
123
FAULT