Hirschmann qSCALE maestro - Page 72

WIKA Mobile Control LP
1540 Orchard Drive
Chambersburg, PA 17201
qSCALE maestro (PLC v01.00.00) Service Manual / Issue E (HMI v1.0.0) 04/2018 / rbm.
Service : (717) 217-2250
Parts / Sales : (717) 217-2269
www.wika-mc.com
72 /76
HIRSCHMANN MCS
Error Code Description Solution
E1X34
Sensor Error: IOWind1
Check the CAN connections and wiring, the sensor
calibration, and the CAN configuration. Replace faulty sensor
E1X38
Sensor Error: IOIncX1
Check the CAN connections and wiring, the sensor
calibration, and the CAN configuration. Replace faulty sensor
E1X39
Sensor Error: IOIncY1
Check the CAN connections and wiring, the sensor
calibration, and the CAN configuration. Replace faulty sensor
E1X3C
Sensor Error: IOMaxA2B1
Check the CAN connections and wiring, the sensor
calibration, and the CAN configuration. Replace faulty sensor
E1X44
Sensor Error: IOCutByp1
Check the CAN connections and wiring, the sensor
calibration, and the CAN configuration. Replace faulty sensor
E1X61
Actuator Error: IOCut
Check the CAN connections and wiring, the sensor
calibration, and the CAN configuration. Replace faulty sensor
E1X63
Actuator Error: IORigging
Check the CAN connections and wiring, the sensor
calibration, and the CAN configuration. Replace faulty sensor
E1X6C
Actuator Error: IOLampGreen
Check the CAN connections and wiring, the sensor
calibration, and the CAN configuration. Replace faulty sensor
E1X6D
Actuator Error: IOLampYellow
Check the CAN connections and wiring, the sensor
calibration, and the CAN configuration. Replace faulty sensor
E1X6E
Actuator Error: IOLampRed
Check the CAN connections and wiring, the sensor
calibration, and the CAN configuration. Replace faulty sensor
E1X7E
Actuator Error: IOOutput1
Check the CAN connections and wiring, the sensor
calibration, and the CAN configuration. Replace faulty sensor
E1X7F
Actuator Error: IOOutput2
Check the CAN connections and wiring, the sensor
calibration, and the CAN configuration. Replace faulty sensor
E1X80
Actuator Error: IOOutput3
Check the CAN connections and wiring, the sensor
calibration, and the CAN configuration. Replace faulty sensor