WIKA Mobile Control LP
1540 Orchard Drive
Chambersburg, PA 17201
qSCALE maestro (PLC v01.00.00) Service Manual / Issue E (HMI v1.0.0) 04/2018 / rbm.
Service : (717) 217-2250
Parts / Sales : (717) 217-2269
www.wika-mc.com
73
/76
HIRSCHMANN MCS
Error Code Description Solution
General Errors
E0090 Operating mode changed Not Available
E00FC Controller Not Initialized
The error will clear when the system finishes the
initialization process
E1F00 System Error
Turn the Ignition off and on again. Consult Customer
Service if the error occurs again
E1F01 Timeout
Check the bus cabling or connector. Try turning the Ignition
off and on again. Consult Customer Service if the error
occurs again
E1F02 Timeout
Turn the Ignition off and on again. Consult Customer
Service if the error occurs again
E1F03 Timeout
Turn the Ignition off and on again. Consult Customer
Service if the error occurs again
E1F04 Timeout
Turn the Ignition off and on again. Consult Customer
Service if the error occurs again
E1F05 Timeout
Turn the Ignition off and on again. Consult Customer
Service if the error occurs again
E1F06 Timeout
Turn the Ignition off and on again. Consult Customer
Service if the error occurs again
E1F07 Timeout
Turn the Ignition off and on again. Consult Customer
Service if the error occurs again
E1F10 Computer operation error
Turn the Ignition off and on again. Consult Customer
Service if the error occurs again
E1F18 Serial Number wrong or not set Set Serial Number to valid entry
E1F1F Outputs deactivated
Information: Subsequent errors resulting from another
system error
E1F2F Outputs deactivated
Information: Subsequent errors resulting from another
system error
E1F41 Battery voltage Call Customer Service to have the unit replaced
E1F44 CAN bus network error
Check the CAN cabling and supply voltage. Try turning the
Ignition off and on again. Consult Customer Service if the
error occurs again
E1F4F Version Error Call Customer Service to have the unit or software replaced
E2001 Module Error
Turn the Ignition off and on again. Consult Customer
Service if the error occurs again
E2005 Module Error
Turn the Ignition off and on again. Consult Customer
Service if the error occurs again
E2015 Module Error Select a valid Operating Mode
E3001 Module Error
Turn the Ignition off and on again. Consult Customer
Service if the error occurs again
To Next Page
Loading...
