Hitachi IJ PH - Page 65

3-10
4 Remove the fixing screws (6 pieces) of the hinges(2 positions)
and then remove the controller part from the body.
5Remove the 3 connectors (CN2、CN4、CN8) on EZJ124 board
and the touch panel connection cable. And then remove the fixing screws
(5 pieces) of EZJ124 board and remove EZJ124 board.
Battery connection
cable(CN2)
Connector for
EZJ97 board
(CN4)
EZJ124 board
EZJ97 board
LCD
(Backside of panel)
Touch panel
connection cable
Battery
Connector for
LCD (CN8)
Fixing screws
(5 pieces)
Controller part
Hinges
(2 potions)
Fixing screws
(6 pieces)
!
When inserting the touch panel connection cable
into the connector on EZJ102 board, always hold
both sides of reinforced section for connection (as
shown in the figure) so that the cable is not bent.
Caution