Version 1.1, 02/2014. Copyright 2012 Hitron Technologies
22
Version 1.1, 02/2014. Copyright 2014 Hitron Technologies
22
Hitron CGNV4 User’s Guide
If the login screen does not display, your computer is not configured correctly.
Follow the procedure in Manual IP Address Setup on page 22 and set your
computer to get an IP address automatically. Try to log in again. If you cannot
log in, follow the manual IP address setup procedure again, and set a specific IP
address as shown. Try to log in again.
NOTE: If you still cannot see the login screen, your CGNV4’s IP settings may have
been changed from their defaults. If you do not know the CGNV4’s new
address, you should return it to its factory defaults. See Resetting the CGNV4
on page 25. Bear in mind that ALL user-configured settings are lost.
1.4.1 Manual IP Address Setup
By default, your CGNV4’s local IP address is 192.168.0.1. If your CGNV4 is using the
default IP address, you should set your computer’s IP address to be between
192.168.0.2 and 192.168.0.254.
Take the following steps to manually set up your computer’s IP address to connect to
the CGNV4:
NOTE: This example uses Windows XP; the procedure for your operating system
may be different.
1 Click Start, then click Control Panel.
2 In the window that displays, double-click Network Connections.
3 Right-click your network connection (usually Local Area Connection) and click
Properties.
4 In the General tab’s This connection uses the following items list, scroll
down and select Internet Protocol (TCP/IP). Click Properties.
5 You can get an IP address automatically, or specify one manually:
If your network has an active DHCP server, select Get an IP address
automatically.
If your network does not have an active DHCP server, select Use the
following IP address. In the IP address field, enter a value between
192.168.0.2 and 192.168.0.254 (default). In the Subnet mask field, enter
255.255.255.0 (default).
To Next Page
Loading...
Need help?
General
