Version 1.1, 02/2014. Copyright 2012 Hitron Technologies
55
Version 1.1, 02/2014. Copyright 2014 Hitron Technologies
55
Hitron CGNV4 User’s Guide
3.5.1 Adding or Editing a Port Triggering Rule
To add a new port triggering rule, click Add in the Basic > Port Triggering
screen.
To edit an existing port triggering rule, select the rule’s radio button in the Basic
> Port Triggering screen and click the Edit button.
NOTE: Ensure that Enabled is selected in the Basic > Port Triggering screen in
order to add or edit port triggering rules.
The following screen displays.
Timeout (ms) This displays the time (in milliseconds) after the CGNV4
opens the Target ports that it should close them.
Twoway Status Usually a port triggering rule works for two IP
addresses; when a rule is enabled, other IPs will also be
allowed to use the rule as a trigger.
Status Use this field to turn the rule On or Off.
Add Click this to define a new port triggering rule. Port
triggering must first be set to Enabled. See Adding or
Editing a Port Triggering Rule on page 55 for
information on the screen that displays.
Edit Select a port triggering rule’s radio button and click this
to make changes to the rule. Port triggering must first be
set to Enabled. See Adding or Editing a Port Triggering
Rule on page 55 for information on the screen that
displays.
Delete Select a port forwarding rule’s radio button and click this
to remove the rule. The deleted rule’s information
cannot be retrieved.
Help Click this to see information about the fields in this
screen.
Table 17: The Basic: Port Triggering Screen (continued)
To Next Page
Loading...
Need help?
General
