Version 1.1, 02/2014. Copyright 2012 Hitron Technologies
94
Version 1.1, 02/2014. Copyright 2014 Hitron Technologies
94
Hitron CGNV4 User’s Guide
The following table describes the labels in this screen.
Table 34: The Security: Service Filter Add/Edit Screen
Application Name Enter a name for the application for which you want to
create the rule.
NOTE: This name is arbitrary, and does not affect
functionality in any way.
Protocol Use this field to specify whether the CGNV4 should filter
via:
Transmission Control Protocol (TCP)
User Datagram Protocol (UDP)
NOTE: If in doubt, leave this field at its default (TCP).
Port Range Use these fields to specify the start and end port for
which this filtering rule applies. These are the ports to
which traffic will be blocked.
Enter the start port number in the first field, and the end
port number in the second field.
To specify only a single port, enter its number in both
fields.
Rule Status Use this field to select whether the filtering rule should
be active or not.
Select Enabled to activate the rule. Matching traffic
will be blocked.
Select Disabled to deactivate the rule. Matching
traffic will not be blocked.
To Next Page
Loading...
Need help?
General
