Service Menu - Continued
139 Bell Test
By selecting Bell Test the panel will activate the buzzer,
internal siren(s) and external siren(s) in sequence.
Note: You will be prompted on the display to go outside to hear the external
siren(s).
Default Eng. Code - 4567 Default User Code - 1111 (Irl) 1234 (UK)
49
13 ENG. TOOLS contd.
!
!
!
145 Part Set B ?
144 Part Set A ?
143 Quick Arm ?
142 Full Set ?
141 Unset ?
14 ENG. ARM/DISARM Used to arm the panel from within engineer mode. Once an
item is selected the panel will automatically exit the engineer
mode and start arming the panel. Once armed in this fashion
the panel can then be disarmed once by the engineer code.
This enables full testing of the system by an Engineer without
having to know somebody’s User code.
15 DEFAULTS MENU
16 FIRMWARE UPDATE
Used to default the panel and other devices back to their
factory settings. There are five default options to choose from
so that different areas of the system can be defaulted without
affecting other areas.
Default all? defaults all devices and configurations on the
system. Default User Codes? defaults the User and Engineer
codes (but not their names, options etc.) Default Comms?
defaults the on-board dialer and plug-on GSM unit. Default ID
Bus? defaults devices on the ID bus and finally Default RF
System? defaults wireless devices.
Note: please refer to the back of this manual for details of panel default
settings.
In the first instance, you need to be connected to SmarkLink7
to update your firmware (i.e your panel’s software).
Select Firmware Update, you will then be prompted to key-in
the Mfg. Code:------ (Manufacturer’s Code). By default it is
4567. Therefore, key-in 4567 followed by YES. You will then be
prompted to key-in the User Code:------ . When that is done,
the display should say Start File Transfer. Next, go to the
relevant page in the Quantum section of SmartLink7 and select
File Transfer. This starts updating the firmware.
Note: If you have already commissioned your alarm system (e.g. Zone
descriptions, timers, devices etc.); this feature DOES NOT affect its
configuration.
151 Default All?
152 Default User Codes?
153 Default Comms?
154 Default ID Bus?
155 Default RF System?
To Next Page
Loading...
Need help?
General
