Digi Defaults
Default Eng. Code - 4567 Default User Code - 1111 (Irl) 1234 (UK)
Yes
hh:mm
30 Seconds
60m
No
Yes
0 Hours
CALL MONITORING.
No
No
12
03
12
03
07
02
00s
00s
Misc. Options
SMS Server Phone No’s Test Call Settings
AVI Settings
NOTE: In Phone Report Menu, only Fire, Panic, Alarm, Pre-alarm, Test Call & Low
Battery are defaulted to report to Central Station phones 1 & 2. All other events
need to be assigned to phones by the installer.
FTC Attempts
Text Enable
Server #1 014297100 Test Start
AVI Time
Retry Period
5 Second Interval
SmartLink700 Progress
Server #2 Test Period
AVI Message
AVI Audio
Using PABX
Max. Attempts
Yes
Yes Yes
No
No
05m No
No
No
Yes No
No
Line Monitor Options
GSM/GPRS IP Settings
Line Monitor On
Monitor Signal DHCP Enabled
Answer Calls
Off-Hook Monitor On
Fault Delay SCPCP Server Enabled
Use Caller ID
Off-Hook/Line Fault (Unset)
Jam Detect SCPCP Server Encryption
Enable GPRS
No
No
No
Modem Options
Use Caller ID
Line Share
Rings Before Answer
SMS Attempts
Voice Attempts
Max SMS Messages
Max Voice Messages
SMS Alarm Delay
Voice Message Delay
Not Programmed
Not Programmed
Not Programmed
Not Programmed
Not Programmed
Not Programmed
Not Recorded
Not Recorded
Extended SIA
Extended SIA
Voice
Voice
Monitoring/Voice Ph. Nos.
Account No. Site Name Protocol
Phone
1
2
3
4
Yes
Yes
Yes
Wait for Dial Tone
Phone
1 to 4
SMS
SmartLink700
Fire
Fire
Alarm
Intruder Alrm
Open/Close
Zone Omit
Mains Fail
Confirm Alrm
Panic
Panic
Pre-alarm
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Positive
Positive
Positive
Positive
Positive
Positive
Positive
Positive
Positive
Positive
Positive
0 secs.
0 secs.
20 secs.
30 secs.
0 secs.
0 secs.
*0 secs.
*0 second channel delay after 55 minutes of no mains
30 secs.
20 secs.
0 secs.
0 secs.
Type
Type
Restore
Restore
Trigger
Trigger
Delay
Delay
Channel
Channel
In the UK...
1
1
3
3
4
5
6
7
2
2
7
Options
No
Dual Report
Yes
No
No
No
No No
Alarm
Arm
System
Soak
Fire Exit Device
SMS Phone
1 to 5
Universally...
Note: The panel can be reconfigured in Engineer Mode or through the PC application,
SmarkLink700. Therefore, the I&HAS may be rendered non-compliant to the EN 50131 suite of
standards (or compliant only to Grade 1) if not done properly. In such a case please remove or amend
any compliance labelling.
!
92