84
Default Eng. Code - 4567 Default User Code - 1111 (Irl) 1234 (UK)
Comms Menu - Continued
945 TEST MESSAGES
1 TEST START
2 TEST PERIOD
!
!
During an installation, the installer can programme the system
to make its first SMS test message at a specific time into the
future. Select Test Start and key-in the hours and minutes of
the first test call.
Note: This will be the first and only test call unless you also select a test
period. See below...
Following on from the first SMS test message, subsequent test
messages can be made at a set interval. Select the number of
hours of this interval by keying-in a number in Test Period
Note: In the UK the Test Start is pre-programmed with a random time and the
Test Period is 24h by default. Reprogram to 0h to deactivate test messages.
95 REMOTE USER MENU
Remote User Names; user names enable more detailed
information to be displayed in the system log
The Remote User Codes menu is used to program remote
user codes for remote users 1 to 7. Remote users can access
their system with SmartLink700 (an up/download application)
at an off-site or remote location. Each remote user code is
required to be 4-6 digits in length. The digit 0 is not allowed.
New codes must be verified in order to be accepted.
951 REMOTE USER CODES
952 REMOTE USER NAMES
953 REMOTE USER OPTIONS
Remote User Options; each remote user can be assigned a
number of options. These are explained as follows...
- Call back enables the panel to make a call to one of its pre-programmed
remote user phone numbers in the event that the Digi has received an
incoming call from a number that it recognises. Note: Please verify that caller
ID is enabled on the phone line that you intend to use this feature on and that
it functions properly.
- With Rem. Set set to NO, SmartLink700 is prevented from remotely setting
(or arming) the panel
- With Rem. Unset set to NO, SmartLink700 is prevented from remotely
unsetting the panel
!
Remote User Options ceased from version 3.2.0 onwards.
To Next Page
