HNC Electric HSD7-E Series - Page 37

31
restart
n.1
CN1-9,10
Output /BK signal from CN1-OUT1
n.2
[Factory setting]
CN1-11,12
Output /BK signal from CN1-OUT2
n.3
CN1-32,33
Output /BK signal from CN1-OUT3
n.4
CN1-34,35
Output /BK signal from CN1-OUT4
n.5
CN1-36,37
Output /BK signal from CN1-OUT5
n.6
---
Don't use /BK signal
Important
When multiple signals are distributed to the same output terminal, OR logic is used for signal output. Please
avoid duplication with other signals when distributing /BK signals.
In particular, please avoid distributing the rotation detection output (/TGON) signal and /BK signal to the
same output terminal. If it is distributed to the same terminal, the /TGON signal will be turned ON at the
speed of falling down on the vertical axis, which may cause the brake not to operate.