User manual C4 – C6
21
Hot parts of the engine and components of the
hydraulic system can cause burn injuries.
When disconnecting hydraulic lines and hoses,
precautionary measures must be taken to ensure that
the line/hose is no longer under pressure once the
supply of energy to the system has been switched off.
Ensure that the outrigger legs are not extended too far
to prevent contact between the ballast and outrigger
legs during slewing.
It is prohibited to raise the jib beyond 70°.
Avoid contact with the outrigger legs when setting or
retracting the outriggers (crushing danger).
Never transport a loaded compact crane, except with
pick and carry option.
Always collapse the crane after use in case of possible
windy conditions when not in use.
Mind the height restriction in covered areas.
When working in a poorly lit environment, artificial light
must be used to ensure that operations involving the
compact crane can be performed safely.
Make sure there are no loose parts present on the
boom during lifting operations.
The boom is flexible and bends when lifting the load.
Be aware that when the load is released the boom will
bend back.
The lifting point on top of the jib is only intended for
lifting the loose jib; it is forbidden to use it to lift a load
or lash the machine in place.
To Next Page
Loading...