HOEFLON C4 - Page 85

User manual C4 – C6
85
Fault code
Problem
Possible solution. If this does not work, contact Hoeflon.
E063
Not used
E064
Not used
E065
Not used
E066
Problem with connection
Switch machine off and on again.
E067
Problem with connection
Switch machine off and on again.
E068
Not used
E069
Not used
E070
Problem with connection
Switch machine off and on again.
E071
Problem with connection
Switch machine off and on again.
E072
Not used
E073
Not used
E074
Problem with connection
Switch machine off and on again.
E075
Problem with connection
Switch machine off and on again.
E076
Not used
E077
Not used
E078
No contact with left-front angle sensor
Switch machine off and on again.
E079
Incorrect value left-front angle sensor
Switch machine off and on again.
E080
Incorrect value left-front angle sensor
Switch machine off and on again.
E081
Problem left front
Contact Hoeflon or your dealer.
E082
Problem left-front length sensor
Activate the bypass and slide out farther. The fault code disappears.
Switch the bypass off.
E083
Problem left-front length sensor
Activate the bypass and slide out farther. The fault code disappears.
Switch the bypass off.
E084
Not used
E085
No contact with right-front angle sensor
Switch machine off and on again.
E086
Incorrect value right-front angle sensor
Switch machine off and on again.
E087
Incorrect value right-front angle sensor
Switch machine off and on again.
E088
Problem right front
Contact Hoeflon or your dealer.
E089
Problem right-front length sensor
Activate the bypass and slide out farther. The fault code disappears.
Switch the bypass off.
E090
Problem right-front length sensor
Activate the bypass and slide out farther. The fault code disappears.
Switch the bypass off.
E091
Not used
E092
No contact with right-rear angle sensor
Switch machine off and on again.
E093
Incorrect value right-rear angle sensor
Switch machine off and on again.
E094
Incorrect value right-rear angle sensor
Switch machine off and on again.
E095
Problem right front
Contact Hoeflon or your dealer.
E096
Problem right-rear length sensor
Activate the bypass and slide out farther. The fault code disappears.
Switch the bypass off.
E097
Problem right-rear length sensor
Activate the bypass and slide out farther. The fault code disappears.
Switch the bypass off.
E098
Not used
E099
No contact with left-rear angle sensor
Switch machine off and on again.
E100
Incorrect value left-rear angle sensor
Switch machine off and on again.
E101
Incorrect value left-rear angle sensor
Switch machine off and on again.
E102
Problem right front
Contact Hoeflon or your dealer.
E103
Problem left-rear length sensor
Activate the bypass and slide out farther. The fault code disappears.
Switch the bypass off.
E104
Problem left-rear length sensor
Activate the bypass and slide out farther. The fault code disappears.
Switch the bypass off.
E105
Not used
E106
No contact with jib angle sensor
Switch machine off and on again.
E107
Incorrect value jib angle sensor
Switch machine off and on again.
E108
Incorrect value jib length sensor
Activate the bypass and slide out farther. The fault code disappears.
Switch the bypass off.
E109
Not used
E110
No contact with boom angle sensor
Switch machine off and on again.
E111
Incorrect value boom angle sensor
Switch machine off and on again.
E112
Not used
E113
No contact with pressure sensor boom lift
cylinder
Switch machine off and on again.
E114
No contact with pressure sensor boom lift
cylinder
Switch machine off and on again.
E115
Not used
E116
No contact with bin angle sensor
Switch machine off and on again.