HOEFLON C4 - Page 86

User manual C4 – C6
86
Fault code
Problem
Possible solution. If this does not work, contact Hoeflon.
E117
Incorrect value bin angle sensor
Switch machine off and on again.
E118
Incorrect value bin dummy sensor
Check whether dummy plug is connected correctly
E119
Not used
E120
No contact with boom rotation sensor
Switch machine off and on again.
E121
Incorrect value boom rotation sensor
Switch machine off and on again.
E122
Incorrect value boom rotation sensor
Switch machine off and on again.
E123
Not used
E124
Low oil pressure in Yanmar engine
Check engine oil level
E125
Engine temperature too high
Check coolant level
E126
Alternator not charging
Check alternator
E127
Not used
E128
Not used
E129
Not used
E130
Not used
E131
Ballast is crooked
Slide ballast in and out
E132
Ballast is crooked
Slide ballast in and out
E133
Ballast is crooked
Slide ballast in and out
E134
Not used
E135
Oil pressure winch sensor out of range
Contact Hoeflon or your dealer
E136
No contact with pressure sensor
Switch machine off and on again.
E137
Incorrect value pressure sensor
Switch machine off and on again.
E138
Pressure too high
Wind out winch cable, reduce lifting weight
E139
Problem in winch switch
Winch cable can only be wound out
E140
Problem in winch switch
Winch cable can only be wound up
E141
Not used
E142
Not used
E143
Not used
E144
Not used
E145
Not used
E146
Not used
E147
Not used
E148
No contact with level sensor
Switch machine off and on again.
E149
Unequal value level sensor
Switch machine off and on again.
E150
Not used
E151
Not used
E142
Maintenance (minor service)
Contact Hoeflon or your dealer
E153
Maintenance (major service)
Contact Hoeflon or your dealer
E154
Maintenance
Contact Hoeflon or your dealer