HollySys LK Series User Manual

Chapter 4 System Configuration
Beijing HollySys Intelligent Technologies Co., Ltd. All Rights Reserved 49
Figure 4-8 Set User Parameters
4.1.2 Configure HOLLITCP Slave Devices
IO slave station configuration method is as shown in follows, when IO modules are connected by
Ethernet.
4.1.2.1 Add the HOLLITCP MASTER Protocol
Select [Add Protocol] command in right click menu of the [ETHERNET] node, with an Add dialog box
pop up, as shown in Figure 4-9.

HollySys LK Series Specifications

General

Brand	HollySys
Model	LK Series
Category	Controller
Language	English