SecurView DX Workstation V12.0 Quality Control Manual
Chapter 3: QC Activities for the Radiologic Technologist
MAN-09466 Revision 001 Page 9
3: QC Activities for the Radiologic Technologist
Hologic provides QC software (QAWeb Enterprise or MediCal QAWeb) that is used by the
Radiologic Technologist to maintain the operating levels of the SecurView displays. The
software analyzes the results of display calibration and compliance testing and indicates
whether the displays meet the pre-programmed QC limits established by the manufacturer.
Caution:
Connecting a QAWeb agent to a QAWeb server may overwrite the required Hologic
Policy Map. When connecting to a QAWeb server, contact Technical Support at
+1.800.760.8342 to obtain the correct version of QAWeb that will maintain the
required Hologic Policy Map.
During SecurView system installation, a Service Engineer uses the software to calibrate
the displays. After installation, Radiologic Technologists use the software for the
following two tests:
• Weekly: The Hologic Compliance Test verifies that the displays are performing
within the preprogrammed limits. The Technologist records the results in the
SecurView Weekly QC Form.
• Semi-Annual Auto-Calibration: The QAWeb software calibrates the displays twice
per year to re-establish the operating levels. The Technologist records the results in
the SecurView Weekly QC Form.
Note
For the Barco Uniti, High-Brightness, Coronis, and Barco Nio MDNG-5221 displays, the
MediCal QAWeb software runs the tests automatically. For the Barco Nio MDNG-6121
and MDNG-5121 displays, the Technologist must use a photometer and run the tests
manually as explained in section Manually Calibrating Displays on page 31
.
To Next Page
Loading...
