SecurView DX Workstation V12.0 Quality Control Manual
Chapter 5: Manually Calibrating Displays
MAN-09466 Revision 001 Page 31
5: Manually Calibrating Displays
5.1 Manually Calibrating Displays using QAWeb Enterprise
This section requires a user to access the Windows desktop. This may be accomplished in
one of two ways: (1) via the SecurView Application login prompt, or (2) via the Windows
login prompt.
5.1.1 Access the Desktop via SecurView Application
1. Log out of the SecurView DX application.
2. Log into SecurView as an Administrator user.
Note
If not customized, the default SecurView administrator credentials are:
Username: admin
Password: admin
3. Select the Exit to Windows tab. Wait until the application has fully closed.
4. Skip to the section Launch the Local QAWeb Application on page 32
.
5.1.2 Access the Desktop via Windows Login
1. At the task bar, select Start, select the User icon, then select Sign Off.
2. Log into Windows as the customer administrator.
Note
If not customized, the default customer Windows credentials are:
Username: customer
Password: Simply-The-Best
3. Continue to the next section.
To Next Page
Loading...
