Honda Electronics HE-6801 - Page 31

25
Store data from card to unit
Select [8.OTHERS][2. MEMORY CARD]
[2.READ FROM CARD TO UNIT] and press
right side of [CENTER] key.
Enter block number of card which you read by
[NUMBER] key and press [SET] key.
Red block number indicates some data is
stored in that block.
Select item which you read by [CENTER] key
up or down and press [SET] key.
Red letter item indicates that item’s data is
stored in card.
If data is not stored in unit, copy is completed.
When data is stored in unit, Select item on
below figure by [SET] key or [NUMBER] key.
1
2
3
4
<READFROMCARDTOUNIT>
BLOCKNUMBEROFSTOREDCARD
＝
RED:USE WHITE:UNUSED
0 1 2 3 4 5 6 7 8 9
1WAKE
2WAYPOINT
3EVENTMARK
4DRAWLINE
5ROUTE
6ALLDATA
(RED:USED)
COPYBY[SET]KEY

<READWAKETOUNIT>
DATAISINCARD
SET:OVERWRITE
CLR:CANCEL
1:AFTERDELETEUNITDATA,
READFROMCARD
2:ADDCARDDATATO
UNITDATA

CLR key
SET key
CENTER key
NUMBER key