Honeywell Accenta Series User Manual

Accenta/Optima Engineer’s Manual
13
Factory Set Condition
User code1 0123
User code2 Not programmed
Duress Code Not programmed
Engineer Code 9999
External siren Bell Duration 15 minutes
External siren Bell Delay No delay
Rearm Count 3 Rearms
Program 1
Zone 1 Timed
Zone 2 Timed inhibit
Zone 3 - 8 Immediate
Exit time 30 seconds
Entry time 30 seconds
Exit mode Timed
Program 2
Zone 1 Timed
Zone 2 Timed inhibit
Zone 3 - 8 Immediate
Exit time 30 seconds
Entry time 30 seconds
Exit mode Disabled
Program 3
Zone 1 Timed
Zone 2 Timed inhibit
Zone 3 - 8 Immediate
Exit time 30 seconds
Entry time 30 seconds
Exit mode Disabled
Zones
Security zones Zones 1 - 8
Standard Fire zones None programmed
Double Knock zones None programmed
Omit prevent zones All programmed
Flag 1
Silent PA No
RKP PA Enable Yes
Engineer Reset No
User reset PA No
User Reset Fire No
Bell in Fire No
Enable Zone 7 as Fire No
Enable Zone 8 as Fire No
NOTE: Zone debounce period is 400 ms
Flag 2
Single Key setting No
Strobe on setting No
Flag 3
Accenta Optima Version X.XX
NOTE: X.XX indicates panel version eg 1.00
Factory Conditions
Refer to page 17, Defaulting Panel to
Factory Settings for the method of
defaulting the panel.

Honeywell Accenta Series Specifications

General

Zones	8
Power Supply	230V AC
Battery Backup	Yes
Tamper Protection	Yes
Communication Format	Contact ID, SIA
Communication	Wired
Compatible with	Honeywell detectors and accessories
Outputs	2