Honeywell Accenta Series User Manual

Accenta/Optima Engineer’s Manual
43
LCD Keypad:
• Enter the premises by the agreed entry route. Thesystem
produces an entry tone. The Power LED is ON and the
Day LED is OFF indicating that the system is set.
• Enter your 4-digit code (0123 default).
• The system unsets with a double beep. The Day LED
comes ON indicating that the system is unset.
• After 30 seconds the Day Mode display appears.
Resetting After an Alarm, Tamper or PA
The system may be programmed to be reset by the user or the installer. This is dependent on System flags set
up. See Menu 3, Set Up System Flags.
The duration of the audible alarm is subject to the Bell Time (menu 7.1=Set Up Timers.Bell Time)
NOTE: The user can reset a PA or Fire alarm only if the function is enabled in System Flags menu 3.1.4 and
3.1.5. respectively.
LED Keypad:
• Enter the premises by the agreed entry route. Thesystem
produces an entry tone. The Power LED is ON and the
Day LED is OFF indicating that the system is set.
• Enter your 4-digit code (0123 default).
• The system unsets with a double beep. The Day LED
comes ON indicating that the system is unset.
TA
PA
Day
Power
TA
PA
Day
Power
[4-digit code]
User Reset - LCD Keypad:
When system is in alarm or tamper:
• Enter a valid user code.
• Press the [RESET] button. The LED goes OFF.
• The system resets and goes into day mode.
• After 30 seconds the day mode display appears
User Reset - LED Keypad:
• When system is in alarm or tamper:
• Enter a valid user code. The appropriate LED will be
flashing.
• Press the [RESET] button. The LED goes OFF.
• The system goes into day mode. The Day LED is on.
TA
PA
Day
Power
TA
PA
Day
Power
[RESET]
Operating System (cont’d)
Unsetting the System
Sunday 01-JanSunday 01-Jan
Sunday 01-JanSunday 01-Jan
Sunday 01-Jan
10:30 10:30
10:30 10:30
10:30
[4-digit code]
SundaySunday
SundaySunday
Sunday
01-Jan01-Jan
01-Jan01-Jan
01-Jan
10:30 10:30
10:30 10:30
10:30
** SYSTEM UNSET **** SYSTEM UNSET **
** SYSTEM UNSET **** SYSTEM UNSET **
** SYSTEM UNSET **
User RestoreUser Restore
User RestoreUser Restore
User Restore
Press ResetPress Reset
Press ResetPress Reset
Press Reset
[RESET]
SundaySunday
SundaySunday
Sunday
01-Jan01-Jan
01-Jan01-Jan
01-Jan
10:30 10:30
10:30 10:30
10:30
** SYSTEM UNSET **** SYSTEM UNSET **
** SYSTEM UNSET **** SYSTEM UNSET **
** SYSTEM UNSET **
[User Code]

Honeywell Accenta Series Specifications

General

Zones	8
Power Supply	230V AC
Battery Backup	Yes
Tamper Protection	Yes
Communication Format	Contact ID, SIA
Communication	Wired
Compatible with	Honeywell detectors and accessories
Outputs	2