Accenta/Optima Engineer’s Manual
44
Engineer Reset - LCD Keypad:
After a tamper an engineer reset is required if the Engineer Reset flag is enabled.
• Enter your user code [0123] default. When System is
in Tamper the appropriate LED will be flashing.
NOTE: Only the first event will cause the LED to flash.
Subsequent events will have a steady ON condition.
• Enter your 4-digit engineer code (9999 default). The
Tamper LED goes OFF and the system resets
• The system is in day mode. The Day LED is on.
TA
PA
Day
Power
[engineer code]
Operating System (cont’d)
Engineer RestoreEngineer Restore
Engineer RestoreEngineer Restore
Engineer Restore
RequiredRequired
RequiredRequired
Required
ContactContact
ContactContact
Contact
EngineerEngineer
EngineerEngineer
Engineer
Restored byRestored by
Restored byRestored by
Restored by
EngineerEngineer
EngineerEngineer
Engineer
SundaySunday
SundaySunday
Sunday
01-Jan01-Jan
01-Jan01-Jan
01-Jan
10:30 10:30
10:30 10:30
10:30
[engineer code]
• Enter your user code [0123] default. If the system has to be set
by an engineer the message Engineer Restore Required is
displayed.
• Enter your 4-digit engineer code (9999 default).
• The system resets and goes into day mode.
[user code]
Engineer Reset - LED Keypad:
After a tamper an engineer reset is required if the Engineer Reset flag is enabled.
[user code]
TA
PA
Day
Power
To Next Page
Loading...
Need help?
General
