Accenta/Optima Engineer’s Manual
42
Operating System
Operating the System
This section gives a brief description of how to set and unset the system as well as how to reset after an alarm.
For further information please refer to the Gen 4 Series User Guide.
Setting the System
LCD Keypad:
• The system shows the day mode display. The system is unset.
The Power and Day LED’s are ON.
• Enter your 4-digit code (0123 default) and check that the
system is clear (no zone indicators on).
• The exit tone begins to sound and the display shows either
program 1, 2 or 3 is in the process of setting.
• Leave the premises by the agreed exit route.
• The exit tone becomes rapid during the last 10 seconds and
then stops when the system sets. The Day LED goes OFF.
• After 30 seconds the day mode display appears.
LED Keypad:
• The system is unset. The Power and Day LED’s are ON.
• Enter your 4-digit code (0123 default) and check that the
system is clear (no zone indicators on).
• The exit tone begins to sound to indicate that the system is
in the process of setting.
• Leave the premises by the agreed exit route.
• The exit tone becomes rapid during the last 10 seconds and
then stops when the system sets. The Day LED goes OFF.
TA
PA
Day
Power
TA
PA
Day
Power
[4-digit code]
Enter Your CodeEnter Your Code
Enter Your CodeEnter Your Code
Enter Your Code
********
********
****
[4-digit code]
Program 1 SetProgram 1 Set
Program 1 SetProgram 1 Set
Program 1 Set
** SYSTEM SET **** SYSTEM SET **
** SYSTEM SET **** SYSTEM SET **
** SYSTEM SET **
TuesdayTuesday
TuesdayTuesday
Tuesday
27-Jun27-Jun
27-Jun27-Jun
27-Jun
14:10 14:10
14:10 14:10
14:10
TuesdayTuesday
TuesdayTuesday
Tuesday
27-Jun27-Jun
27-Jun27-Jun
27-Jun
14:10 14:10
14:10 14:10
14:10
To Next Page
Loading...
Need help?
General
