Honeywell CNI2 - Over-The-Air (Ota) Programming; Over-The-Air Configuration Changes; What Is Over-The-Air Programming

CNI2
O
perating and Installation
Guide
99
OVER
-
THE
-
AIR (OTA) PROGRAMMIN
G
What is Over
-
the
-
Air Programming?
The
CNI2
’s configuration and/or its operating program (called “firmware”) can be changed once
the unit i
s installed in the field. This is called over
-
the
-
air (OTA) programming. At the present
time this feature is only supported when using the
DC
-
2009
®
data collection system
and then
only in Internet (IP) mode
. MV90
®
does not support OTA changes
and
DC
-
200
9
®
does not
support OTA in CSD mode
.
NOTE
The remote unit ID (RUID) and Service Type (GSM or CDMA) cannot be changed
over
-
the
-
air.
These can only be changed using a programming cable.
WARNING
In some case and in some countries (Canada for example) a
metering device is not allowed
to have its program or configuration changed over
-
the
-
air.
Over
-
the
-
Air
Configuration Changes
Both MP32
®
and
DC
-
2009
®
must be running on the same system at the same time.
The
PROGRAM ACCOUNTS / LISTS
button
on the bottom of the main MP32 screen will be enabled
only
when both programs are running.
Set up all configuration items as you would for any
CNI2
. The
n
select the
PROGRAM
ACCOUNTS / LISTS
button
on the bottom of the main MP32 screen. The following scr
een will
appear.
IMPORTANT
It is extremely important that all configuration parameters be correct, especially those
related to the cellular network.
Otherwise the CNI2 may not be able to conta
ct the central office again.
This will require an on
-
site visit to correct the problem.