perating and Installation
Next you must define the pulse
ting interval, which applies to all channels that are
counting. Highlight one of the remaining channels on the screen and select
the CONFIGURE button (or simply double
click on the selected channel). The following screen
Data Input Configuration Screen
Select the Input Definition tab. Here you can match the time interval to that which was
programmed into the CNI2. This will apply to all pulse
counting channels. You can also change
the description of each channel
and select which type of data to save. Contact a Product
Service Specialist if you need additional help with other selections on this screen.
To Next Page
Loading...
Need help?
General
