Xenon/Granit User Guide 89
When the scanner is out of the base, press the page button on the base to make the
associated scanner start beeping (3 short and 1 long beep). If you pull the trigger
on a scanner that is beeping in response, or press the Page button on the base a
second time, the scanner stops beeping. See Paging on page 90 for further infor-
mation about Page Button settings.
Page Button with Scanner in the Base
When the scanner is in the base, press the page button on the base to begin
Streaming Presentation Mode. The scanner acts as a presentation scanner for 10
seconds. If a bar code is scanned before the 10 second timeout is reached, the
timer starts over. Lift the scanner from the base to return to manual triggering. To
change the timeout from 10 seconds see Temporary Streaming Presentation
Timeout on page 89.
Temporary Streaming Presentation Timeout
Set a timeout for the length of time the illumination remains on and searching for
bar codes when using Temporary Streaming Presentation Mode. Set the length for
the timeout by scanning one of the bar codes below. Default = 10,000 ms (10 sec-
onds).
See Paging, below, for further information about Page Button settings.
To Next Page
Loading...
