Xenon/Granit User Guide 65
Multiple Scanner Operation
Note: Multiple Scanner Operation Mode allows you to link up to 7 scanners to one base or
Access Point. You cannot join an 8th scanner until you unlink one of the 7 scanners
or take a scanner out of range.
To put the scanner in multiple scanner mode, scan the bar code below. Once you
scan this bar code, the scanner is unlinked from the base or Access Point and must
either be placed into the base, or you must scan the Access Point linking bar code
in order to relink.
Scanner Name
You may assign a name to each scanner you are using for identification purposes.
For example, you may want to have a unique identifier for a scanner that is receiv-
ing imaging commands sent from the base or Access Point.
The default name is in the format “ScannerName_Model_SN_XXXXXXXXXX” If you
have more than one scanner linked to a base, and they all have the same name, the
first scanner linked to the base receives commands. When renaming a series of
scanners with identical names, unlink all except one of the scanners from the base.
* Batch Mode Transmit Delay Off
(No Delay)
Batch Mode Transmit Delay Short
(250 ms)
Batch Mode Transmit Delay Medium
(500 ms)
Batch Mode Transmit Delay Long
(1000 ms)
Multiple Scanner Operation
To Next Page
Loading...
