Honeywell Granit 1981i - Delete Last Code; Clear All Codes; Transmit Records to Host; Batch Mode Transmit Delay

64 Xenon/Granit User Guide
Delete Last Code
If you want to delete the last bar code scanned when in Batch Mode, scan Delete
Last Code.
Clear All Codes
If you want to clear the scanner’s buffer of all data accumulated in Batch Mode,
scan Clear All Codes.
Transmit Records to Host
If you are operating in Inventory Batch Mode (see Inventory Batch Mode on page
60), you must scan the following bar code to transmit all the stored data to the host
system.
Batch Mode Transmit Delay
Sometimes when accumulated scans are sent to the host system, the transmission
of those scans is too fast for the application to process. To program a transmit
delay between accumulated scans, scan one of the following delays. Default = Off.
Note: In most cases, a short (250 ms (milliseconds)) delay is ideal, however, longer delays
may be programmed. Contact Technical Support (page xvii) for additional
information.
Total Records
Delete Last Code
Clear All Codes
Transmit Inventory Records