322 Xenon/Granit User Guide
3. Turn the base upside down.
4. Pull the connector out while maintaining pressure on the connector release
clip.
5. Replace with the new cable.
Insert the connector into the opening and press firmly. The connector is keyed
to go in only one way, and will click into place.
Changing a Xenon Scanner Battery
1. Use a Phillips head screwdriver to remove the screw from the end cap.
2. Remove the end cap and remove the battery from the handle.
3. Insert replacement battery.
4. Replace end cap and screw.
CCB01-010BT Base:
CCB02-100BT/CCB05-100BT Base:
To Next Page
Loading...
