Xenon/Granit User Guide 263
The scanner scans until a bar code has been read, until the deactivate command is
sent, or until the serial time-out has been reached (see Read Time-Out on page
119 for a description, and the serial command on page 276).
Reset the Custom Defaults
If you want the custom default settings restored to your scanner, scan the Activate
Custom Defaults bar code below. This resets the scanner to the custom default
settings. If there are no custom defaults, it will reset the scanner to the factory
default settings. Any settings that have not been specified through the custom
defaults will be defaulted to the factory default settings.
Note: If using a cordless system, scanning this bar code also causes both the scanner and
the base or Access Point to perform a reset and become unlinked. The scanner must
be placed in its base to re-establish the link. If using an Access Point, the linking bar
code must be scanned. See Cordless System Operation: Xenon 1902g/1912 and
Granit 1911i/1981i beginning on page 41,or Cordless System Operation: Xenon
1902g-BF beginning on page 79 for additional information.
The charts on the following pages list the factory default settings for each of the
commands (indicated by an asterisk (*) on the programming pages).
To Next Page
Loading...
