Honeywell Granit 1981i - Check Digits Required; Code 11 Message Length

192 Xenon/Granit User Guide
Code 11
<Default All Code 11 Settings>
Code 11 On/Off
Check Digits Required
This option sets whether 1 or 2 check digits are required with Code 11 bar codes.
Default = Two Check Digits.
Code 11 Message Length
Scan the bar codes below to change the message length. Refer to Message Length
Description (page 178) for additional information. Minimum and Maximum
lengths = 1-80. Minimum Default = 4, Maximum Default = 80.
On
* Off
One Check Digit
* Two Check Digits
Minimum Message Length
Maximum Message Length