Honeywell Granit 1981i - NEC 2 of 5 Message Length; Code 93

Xenon/Granit User Guide 187
When Check Digit is set to Validate and Transmit, the scanner only reads NEC 2 of
5 bar codes printed with a check digit, and will transmit this digit at the end of the
scanned data. Default = No Check Digit.
NEC 2 of 5 Message Length
Scan the bar codes below to change the message length. Refer to Message Length
Description (page 178) for additional information. Minimum and Maximum
lengths = 2-80. Minimum Default = 4, Maximum Default = 80.
Code 93
< Default All Code 93 Settings >
Code 93 On/Off
* No Check Digit
Validate, but Don’t Transmit
Validate and Transmit
Minimum Message Length
Maximum Message Length
* On