Xenon/Granit User Guide 93
Base Address
Scan the bar code below to determine the address of the base you are using.
Scanner Modes
Charge Only Mode
There may be times when you want to charge your scanner, but not link to the base.
In order to program the base for Charge Only Mode, you must link the scanner to it.
Once the scanner is linked to the base, scan the Charge Only Mode bar code. Any
subsequent scanners placed in that base will charge without linking to it. The
scanner used to program the base remains linked to the base. To unlink this scan-
ner, scan Unlink Scanner on page 94.
Note: When in Charge Only Mode, the scanner periodically wakes up and beeps. See Power
Up Beeper on page 111 to change this setting.
Charge and Link Mode
If you want to charge a scanner and link to the base, use Charge and Link Mode. If
the base is programmed for Charge Only Mode, you must link a scanner to it first in
order to program it for Charge and Link Mode. Scan the linking bar code on the
base to link the scanner, then scan Charge and Link Mode. Default = Charge and
Link Mode.
Linked Modes
Locked Link Mode and Open Link Mode are the link modes that accommodate dif-
ferent applications. Scan the appropriate bar codes included in the Open Link and
Locked Link Mode explanations that follow to switch from one mode to another.
Default = Open Link Mode.
To Next Page
Loading...
