Honeywell Granit 1981i - Maxicode

222 Xenon/Granit User Guide
Data Matrix Code Page
Data Matrix Code pages define the mapping of character codes to characters. If the
data received does not display with the proper characters, it may be because the
bar code being scanned was created using a code page that is different from the
one the host program is expecting. If this is the case, scan the bar code below,
select the code page with which the bar codes were created (see ISO 2022/ISO 646
Character Replacements on page 334), and scan the value and the Save bar code
from the Programming Chart, beginning on page 341. The data characters should
then appear properly.
MaxiCode
< Default All MaxiCode Settings >
MaxiCode On/Off
Off
Data Matrix Code Page
On
* Off